Hard-earned money

To overcome this problem in the shortest possible time is the need of the hour, as time is money. In this time of financial crisis, DeBurring Brushes & Holders brings cost-effective and appropriate solutions for DeBurring, Micro DeBurring, Surface Preparation and Radiusing needs on same Machining Center like VMC / HMC machines on both metal and non-metal.

Presently, DeBurring Brushes & Holders is more focused on catering solutions to every DeBurring problem faced during machining. In today's very fast, most modern and intelligent machines, productivity has increased in multiplications beyond limits, as a result free availability of Burr on most operations.

It is the right time to think of introducing a few new things to a present Machining system, which will save a lot of time and hard-earned money; it's time to contact a DeBurring Solution provider, IMEXSU, which has been one since 1976.

The range of MID machining center is unique, and that's tomorrow's need, but the center is ready to offer today. To overcome this problem in the shortest possible time is the need of the hour, as time is money or just a few form wide range.

With water flow through,brushes from Dia. 100 and above are also available in water flow through.The brushes are available from Diameter 50, 60, 80, 100, 125, 160, 165, 180, 200, 225, 250 & 296 and many more.Grit available from 46 to 1000 more, and types are Diamond, Ceramic, Silicon, Aluminum, etc.IMEXSU has more then 76 types of center's products to suit every individual's needs.IMEXSU offers standard holders to be fitted directly to present holders like BT, ISO, HSK and others, with shank sizes Diameter 12, 16, 20, 25, 32 & 40mm with or without side-lock to be directly fitted to holder with help of Collete, Hydro-grip, Shrink-fit, Side-locks.

Unless otherwise stated, the content of this page is licensed under Creative Commons Attribution-ShareAlike 3.0 License